LOW VOLTAGE DISCONNECT : VICTRON ENERGY BATTERY PROTECT 12/24V 65A

DescriptionVictron Battery Protect:The Battery Protect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.Features:  12/24V auto ranging- The BatteryProtect automatically detects system voltageProgramming made easy- The BatteryProtect can be set to engage / disengage at several different voltages. The seven segment display will indicate which setting has been chosen.A special setting for Li-ion batteries- In this mode the BatteryProtect can be controlled by the VE.Bus BMS.Note: the BatteryProtect can also be used as a charge interrupter in between a battery charger and a Li-ion battery. See connection diagram in the manual.Ultra low current consumption- This is important in case of Li-ion batteries, especially after low voltage shutdown. Please see our Li-ion battery datasheet and the VE.Bus BMS manual for more information.Over voltage protection- To prevent damage to sensitive loads due to over voltage, the load is disconnected whenever the DC voltage exceeds 16V respectively 32V.Ignition proof- No relays but MOSFET switches, and therefore no sparks.Delayed alarm output- The alarm output is activated if the battery voltage drops below the preset disconnect level during more than 12 seconds. Starting the engine will therefore not activate the alarm. The alarm output is a short circuit proof open collector output to the negative (minus) rail, max. current 50 mA. The alarm output is typically used to activate a buzzer, LED or relay.Delayed load disconnect and delayed reconnect- The load will be disconnected 90 seconds after the alarm has been activated. If the battery voltage increases again to the connect threshold within this time period (after the engine has been started for example), the load will not be disconnected. The load  will be reconnected 30 seconds after the battery voltage has increased to more than the preset reconnect voltage.Specifications:BatteryProtectBP-65BP-100BP-220Maximum continuous load current65A100A220APeak current (during 30 seconds)250A600A600AOperating voltage range6 –35VCurrent consumptionWhen on: 1,5 mA When off or low voltage shutdown : 0,6 mAAlarm output delay12 secondsMaximum load on alarm output50 mA (short circuit proof)Load disconnect delay90 seconds (immediate if triggered by the VE.Bus BMS)Load reconnect delay30 secondsDefault thresholdsDisengage: 10,5V or 21V Engage: 12V or 24VOperating temperature rangeFull load: -40°C to 40°C (up to 60% of nominal load at 50°C)ConnectionM6M8M8Weight0,2 kg 0.5 lbs0,5 kg 0.6 lbs0,8 kg 1.8 lbsDimensions (hxwxd)40 x 48 x 106 mm1.6 x 1.9 x 4.2 inch59 x 42 x 115 mm2.4 x 1.7 x 4.6 inch62 x 123 x 120 mm2.5 x 4.9 x 4.8 inch